If you’re simply looking at which gates to choose, then we can help you better in person, so why not contact us for a discussion around your needs.

We’ll get into that shortly, but let’s first look at the critical differences between sliding gates and swing gates. But based on the available install space, swing gates might be a better option and require less maintenance.īut it’s fair to say that sometimes you may not get a choice, it’s all about space. Sliding gates also maximize space because the gate opens sideways rather than inwards. Sliding gates can offer more security as they are harder to force open and provide a greater deterrent. In this article, we’re going to go through how to choose the right automatic gate for you. But what kind should you install? Which automatic gate is better – Sliding or Swing? So you’ve decided it’s time to get electric gates installed into your property in Perth. The gate is now ready for installing a Motor. Pin the ends first and check the gate is lined up from fully closed to open, then install the remainder of the pin anchors. You need to drill holes in the concrete the correct size for the pin anchor, the 6.5mm (1/4') anchor is the most suitable requiring a 6.5mm (1/4') hole. To fit the track use metal pin anchors, which are available at most nut and bolt suppliers as these are quick to fit, look nice and hold better than Dynabolts. Where the track goes behind the fence you'll only need a hole every 500mm (20') on alternate sides as this doesn't need nearly as much strength.īefore fixing the track in place put the gate back on the track again and check that the gate is plumb and that it lines up with the posts and keeper. Where you drive over the track on the driveway you should drill an 8mm (5/16') hole every 500mm (20') on both sides of the track.

Mark out and drill mounting holes in the track as follows: Now remove the gate so you can install the track permanently.

It is important that the guide bracket cannot come loose for safety reasons so the gate doesn't fall over and injure someone. You can now fit the Keeper and guide bracket permanently using suitable hardware. Place the gate on the track and fit the guide rollers or block so you can test whether the gate opens and closes properly without rubbing on the track.Ĭlamp the Keeper where you think it should be then close the gate and if using a guide rail make sure it clears the keeper by at least 10mm otherwise move it down. If using guide rollers or guide bracket, block and rail use Clamps to clamp the bracket to the gate post or wall other wise you will need to install a guide post. Lay the track down where the gate is to be installed but don't fix it in place yet. This makes it easier to move around without scratching it. READ MORE about Posts for Automatic Gates Installing the gateįit the wheels to the gate first using Tek screws. Posts for sliding gates don't need to be as large as those for swing gates. Metal posts are best because they don't warp or twist with changes in weather conditions. READ MORE about Installing Footings for Sliding Gates Installing Posts for Sliding Gates If you have a bitumen or gravel driveway you will need to dig a channel across your driveway and install concrete. If you have a concrete driveway then the footing for your sliding gate is halfway there. Installing the Footing for a Sliding Gate allowing for a Motor The Gate must comply with any applicable local council regulations. Opening and closing to reduce risk of entrapment. When Installing an Automatic Gate that will be entered from a public road way, make sure the Gate is placed far enough from the road to prevent traffic congestion and is installed in a location that provides adequate clearance between it and adjacent structures when

Motorized sliding gate